Hello World

Create the project

Let's create our first embedded Rust project. For this, we will be using esp-generate tool installed earlier.

To begin with, run the following command:

esp-generate --headless --chip=esp32c6 -o log -o unstable-hal hello_world

This will create a new project in hello_world directory. Go ahead and open it with: code hello_world.

💡 You can run esp-generate --chip=esp32c6 to open the tool in interactive mode and explore the available options.

Run

With the ESP board plugged into your computer, you should be able to run the firmware with:

cargo run

You may have to select the appropriate device. If this is the case, the tool will prompt for it.

If everything goes well, your device will boot and start printing the "hello world" message:

INFO - Hello world!
INFO - Hello world!
INFO - Hello world!
INFO - Hello world!
INFO - Hello world!

Experiment

Experiment with this example a little bit.

• Change the message to print something else.
• Change the log level (e.g. to warn).
• Change the printing frequency by adjusting the sleep duration.